亚洲精品在线看 I 亚洲欧美日韩一区二区三区在线观看 I 日韩av第一页 I 婷婷色综合 I 精品av天堂毛片久久久 I 青青草这里只有精品 I 亚洲天堂一区 I 成人三级视频在线观看不卡 I 国产欧美日韩精品a在线看 I 蜜臀av999无码精品国产专区 I 91亚洲精华国产精华液 I 日韩av在线观看免费 I 中文字幕激情视频 I 国产精品国产 I 婷婷视频网 I 色欲天天天综合网 I 亚洲淫片 I 天天看片免费中国一级黄色片 I 欧美日韩综合在线观看 I 性欲av在线 I 免费看一级特黄a大片 I 国产国产成人久久精品 I 色伊人久久 I 久久se精品一区二区 I 国偷自拍第113页 I 人妖欧美一区二区三区 I 国产超碰人人做人人爰 I 国产99精品 I 嫩草视频在线免费观看 I 黄色网在线 I 国产美女搞久久 I 日本打屁股免费网站 I 色小姐在线视频 I 免费黄视频网站 I 伊大人香伊大人香蕉在线视频 t.tui9.xyz

Well submersible pump is mainly water immersion and oil immersion, both of which are composed of water pump and motor. In order to ensure the normal operation of the electric pump, it must be carried out according to the following methods.

1. Before using the electric pump, use a megohmmeter to check the insulation resistance of the motor, and the minimum value should not be less than 5 megohm. The inspection method is to connect a terminal on the megger to the cable line of the electric pump, and connect the other terminal to the motor shell. Shake the megger and observe the insulation resistance value.

2. Check the cable for ground cracks and scratches. If there is any damage, it should be replaced in time to prevent leakage.

3. The water immersion motor should open the irrigation bolt, fill with clean water, tighten the bolt, and then dive into the water. If oil leakage is found in the oil immersed motor, the sealing element should be replaced before diving into the water.

4. Before the electric pump submerges into the water, fill the pump with clean water, empty for 1-2 minutes, and start it twice to check whether the idling and starting are normal. If the direction is opposite, switch the two-phase wiring.

5. Check whether the lifting pipe has cracks and whether the connection is firm.

6. When the electric pump is submerged or lifted, the cable shall not be pulled to avoid cable damage or disconnection at the joint.

7. The power supply voltage should be controlled within 5% of the rated voltage. If the voltage is too high or too low, the motor will be damaged.

8. The electric pump shall be vertical when diving into the water, and shall not be inclined.

9. The electric pump shall not transport water or mud with more sand content. The sand particles in the motor cavity should be cleaned frequently and the clean water in the motor cavity should be replaced.

10. The actual head of the pump should be within 0.8-1 rated head. This can improve the working efficiency of the electric pump, save electricity, avoid overload operation of the motor, and prolong the service life.

11. After the pump is used, it should be cleaned, coated with oil on the metal surface to prevent rust, and keep it in a dry place vertically. Water immersion motor should also discharge clean water in the motor.

Technology Department